How to Clean Golf Clubs: 6 Best Cleaning Processes
Step 1
Fill the bucket with water that is less than 120 degrees Fahrenheit (50 Celsius). If the water is too hot, it can damage the joint where the iron connects to the shaft, causing your iron to leak and become unusable. Squirt a small amount of washing liquid into the bucket. For most irons, fill a separate container with a mild detergent and mix with two cups of lukewarm water. ( Don’t use too much hot water)
Step 2
Place your irons and wedges into the bucket, ensuring that the dirty club heads are fully submerged in the solution. Leave them to soak for a few minutes to loosen any dirt that might be hiding out in the grooves. For now, leave your woods and putters outside of the bucket.
Step 3
Use a soft brush to clean the grooves after allowing your golf clubs to soak in a bowl of warm water and a little detergent or dish soap for 5 or 10 minutes. You can use cleaning kits or soap suds for better results. Never use wire brushes or steel wool in circular motions. This step is essential for removing excess dirt and debris that can damage your iron clubs performance, so it’s well worth the time required. A few simple steps will help you keep your vehicle safe as well as extending your car’s lifespan.
Step 4
Before you do anything else, brush the grooves and back of your iron clean. This process will remove mud, sand, and grass from your clubs so you can focus on the task at hand.
Step 5
Once you’re done cleaning dirty clubs, use a garden hose to rinse off the dirty club head. Ensure that all bubbles have been removed, as wet club heads can slip out of hands during a swing. It’s essential also to check the shaft hasn’t become wet — this will compromise the quality of your golf clubs. Next, place your golf club in the bag and wipe it dry with a towel. Your golf club should not go into the bag wet, as that can lead to mold and mildew growth over time.
Step 6
Constant exposure to extreme heat or cold can deteriorate the glue on the grips and club heads in a climate-controlled area. Therefore, keeping the clubs or golf shoes in the golf bag is essential when it’s not carrying to avoid this problem. In addition, proper storage is necessary to maintain the steel polish.
How to clean metal woods clubs?
Fairway woods, persimmon woods and metal woods need to be cleaned in different ways. For example, you can scrub the latter down with the aid of water.
It is advised that you mix warm water and liquid dishwashing soap (about two teaspoons) in a bowl or plastic bucket.
Use a soft-bristled brush or an old toothbrush and a little soapy water to scrub your dirty golf club head. After brushing, rinse your club under tap water until it’s spotless.
Ensure your metal woods club head is clean by wiping them down with a dry or wet towel.
How to clean wooden clubs?
The oldest and most fragile metal counterparts, Wooden golf clubs, should never be placed in a washing machine. Instead, if your golf clubs have gotten dirty, follow the steps to clean them properly.
- Fill a bucket with warm water, and then wring out a rag. Place the moist cloth inside the bucket, and secure it with the bucket’s cover.
- Take a microfiber towel and wipe the dirt off of your golf club. A dry towel will help you do a more thorough job than if you used the same old towel to wipe down your clubs before using them. Don’t forget to make a quick wipe.
- Always clean your golf club heads after every round. Dry your club thoroughly as a final step with a towel before you put it away.
How to clean golf club grips?
Golf club grips lose traction over time from remaining dirt and sweat. Therefore, cleaning your golf grips is essential for the maintenance process, especially when playing more often. It would be best if you cleaned them at least once every two months. However, if you notice that your grips have become slippery or the tackiness has gone after cleaning clubs, then it is time to buy a new grip.
- Clean a dirty golf club’s grip with water and a cloth. A damp rag will gently scrub the dirt off while not scratching up the leather.
- Dampen a cloth with water, and wipe all surfaces of the grip.
- Rinse the club with a clean stream of water from a hose, or rinse in a tub or bucket with clean water.
- Drying each grip with your towel after it has been rinsed off is the best way to dry it and prevent rust. It is also essential to check the shafts and, if necessary, dry them as well.
How to clean golf club shafts?
After cleaning off the dirt and grime from your golf club heads, don’t neglect the shafts! They can also be prone to dirt. Use a damp cloth to wipe them down and clear away any grime. Then, use a towel to dry them thoroughly.
- You can clean your dirty golf club shafts with vinegar.
- Rub the golf shafts of the club with a soft cloth dipped in vinegar.
- Wipe away any residue with a clean, dry cloth, careful not to scratch the metal surface.
- Damp down with water and wipe the shaft once more to remove any trace of vinegar.
Can I use a wire bristled brush to clean golf clubs?
A wire brush or soft bristle brush is a safe and effective way to remove rust, mud, and debris in golf clubs. However, it would be best if you were careful not to scour off the enamel on the top of your driver’s head.
How do you shine and clean your golf clubs?
Do you need to polish your golf clubs? This guide will show you how to save time and get your clubs looking great. First, you’ll need a medium-size bucket with a block of mild soap and not-so-hot water. Dip the club in the water for several minutes. Next, use a wet rag to scrub off any dirt on the club heads. Next, rinse the club with cold water. Finally, in a circular motion, rub in either a steel or chrome polish.
Can you clean golf clubs with water?
So, you got dirt on your golf clubs and want to clean them. First, put two or three teaspoons of dishwashing liquid or warm soap in the bucket of clean water. Then dip the unclean club heads with a soft bristle brush into the foamy water for five to ten minutes. Next, take the bucket inside the sink or bathtub and add a little dishwashing liquid to the bottom for a foam-covered mixture.
Can you use WD40 on golf clubs?
WD-40, the famous lubricant brand, is essential to many people’s homes, and it’s often used for more than its intended purpose. For example, plenty of folks use WD-40 to clean their golf clubs.
As soon as rust starts to form on your clubs, use this model to get it off. Just spray WD-40 onto the clubs and let it sit for 5-10 minutes. Dry those off with a cloth, and you’re finished. When the rust is gone, you can wash and rinse them.
Final Words:
If you are a golfer, you should know how to clean your golf clubs. A clean club face will allow you to strike the ball and achieve maximum distance properly. Unfortunately, many golfers don’t realize how important and how to clean your clubs, just as they don’t take care of them in the way they should. As you can see, many things go into cleaning your golf clubs.
A clean golf club is a happy golf club, and a clean golf club with optimal performance is what every golfer is after. The cleats should be clean, the grip should be clean, the shaft should be clean, and the face should be clean. We hope our cleaning methods will help you to clean your golf club.
